Installing a deadbolt on a door that has never had one means drilling two holes: a cross bore through the face of the door, usually 2 1/8 inches wide, and a 1 inch edge bore for the bolt. We measure the backset first, the distance from the door edge to the center of the cross bore, which is normally 2 3/8 or 2 3/4 inches, and we use a jig so the holes meet square.
The frame matters as much as the door. We chisel a mortise for the strike plate, drill the bolt pocket deep enough for the full one inch throw, and fasten the strike with long screws that reach the wall stud behind the jamb. A bolt that only half extends, or a strike held by short screws in soft pine, gives way far sooner than the lock itself.
Many brick homes in St. Louis still have the original mortise lock in the front door. We can usually add a deadbolt above it without disturbing the old hardware, as long as the new bore clears the mortise pocket and any glass panel. If the stile is too narrow for a standard backset, we will tell you what will fit before we drill.